while the new iPhones might have gotten
a boost in water resistance they're
definitely not any more drop resistant
so today I'm gonna show you how to
replace the display in your iPhone 10s
max before you begin make sure you
follow the step by step guide on our
website it has lots of tips and tricks
that'll make this repair easier for
safety be sure to drain your battery
below 25% and keep in mind that swapping
out your display will result the loss in
true tone for this repair you're going
to need a pee tube pentalobe screwdriver
a tri point why triple zero driver a
spudger tweezers an eye opener a suction
handle and opening pics we also
recommend using a magnetic mat for this
repair it'll keep your screws organized
and safe from rolling away start by
removing the two pentalobe screws at the
bottom of the phone near the charging
port then heat your eye opener up and
lay it across the iPhone at the bottom
grab your suction handle and press it on
the area you just heated lift up on the
suction handle and insert your pic and
work it around the phone
try not to insert the pic too far
because you could damage cables at the
top of the phone gently pull or wiggle
the display down in the direction of the
Lightning port once you've released all
the adhesive lift the display to the
right slowly you still have cables
connected to the logic board to
disconnect the battery you must first
remove the top bracket unscrew four tri
wing screws and then remove the bracket
disconnect the cable that leads to the
battery first and then remove the three
screws and the smaller bracket below the
battery connector disconnect the display
cables and be careful with the sensor
assembly cable as it's slightly adhered
with the cables disconnected the display
is now free to retain face ID you must
switch over the front sensor assembly to
your new display to do that remove the
three screws holding the assembly in
place unfold the earpiece speaker
downwards and carefully slide a pic
under the cable use the pic to pry up
the mic and the proximity sensor plus
flood illuminator module then use some
tweezers to lift up the ambient light
sensor now the assembly should lift up
and you're ready for your new display
before you install your new display you
should reapply adhesives to keep water
resistance you can choose not to do this
but remember you will lose water
resistance time to reinstall the
earpiece speaker and assembly to your
new display
be sure you insert the flood illuminator
and proximity sensor correctly along
with the ambient light sensor then fold
the speaker back over and screw it back
in place once the display is ready go
ahead and connect the display cables and
make sure you connect the battery lasts
[Music]
everything all connected go ahead and
screw back on all the plates and close
up your phone as you close up your phone
make sure not to pinch any cables
[Music]
and don't forget to screw back in your
pentalobe screws that's all for this
repair be sure to hit like and subscribe
to check out all of our awesome teardown
and repaired videos see you next time
[Music]