batteries are disposable but your
thousand dollar iPhone is not which is
why today I'm going to show you how to
replace the battery in your iPhone 10's
max for safety be sure to drain your
battery below 25% for this repair you're
going to need a P two pentalobe
screwdriver a tripoint Y triple zero
driver a spudger tweezers an eye opener
isopropyl alcohol a suction handle and
opening fix we also recommend using a
magnetic mat for this repair it'll keep
your screws organized and safe from
rolling away start by removing the two
pentalobe screws at the bottom of the
phone near the charging port then heat
your eye opener up and lay it across the
iPhone at the bottom grab your section
handle and press it on the area you just
heated lift up on the suction handle and
insert your pic and work it around the
phone
try not to insert the pic too far
because you could damage cables once
you've released all the adhesive lift
the display to the right slowly you
still have cables connected to the logic
board to disconnect the battery you must
first remove the top bracket unscrew
four tri wing screws and then remove the
bracket
disconnect the cable that leads to the
battery first and then remove the three
screws and the smaller bracket below the
battery connector
disconnect the display cables and be
careful with the sensor assembly cable
as it's slightly adhered
with the cables disconnected the display
is now free remove the three screws on
the taptic engine but be careful with
the ground on the left side you don't
want to lose this piece because you'll
need it when you reassemble your phone
grab your tweezers and remove the plate
covering the connector make sure the
plate is flat and pushed towards the
battery to release it once the plate is
off go ahead and disconnect the cable
under it right below that connector is a
standoff screw remove that next there's
a bracket near the Lightning port being
held down by five screws once those
screws are out you can lift and remove
the bracket
to the right of the speaker remove one
stand off screw and one Phillips screw
use a spudger to lift up the speaker on
the right side while lifting carefully D
route the cable you disconnected near
the taptic engine
use some tweezers to unstick all for the
adhesive tabs
once that's done grab some isopropyl
alcohol and squirt a little bit of it
into the phone under the battery
wait a minute for the adhesive to soften
and the tab should come out with ease
use your tweezers to grab the tabs and
roll the adhesive out
once you've removed all the adhesive
strips the battery should be free to
reassemble your phone you'll need to
apply some brand new adhesive to both
your battery and the display thankfully
we have videos on how to do both once
you have your new battery set in place
go ahead and insert your speaker and the
taptic engine there's a cable under the
taptic engine that you need to reconnect
go ahead and connect the cable on the
speaker and screw the speaker back on
next screw the brackets back in place
be sure to place the ground on the
taptic engine correctly before screwing
it down next grab your display and
connect the display connectors make sure
you connect the battery last everything
all connected go ahead and screw back on
all the plates and close up your phone
as you close up your phone make sure not
to pinch any cables
and don't forget to screw back in your
pentalobe screws
that's all for this repair be sure to
hit like and subscribe to check out all
of our awesome teardown and repaired
videos see you next time