the display on the s10 plus is a thing
of beauty but sadly this beauty isn't
immune to bad luck if you accidentally
dropped your phone and shattered your
screen don't panic because today we're
going to show you how to replace the
display on your Samsung Galaxy S 10 plus
for this repair you'll need an eye
opener a set of iFixit opening pics a
spudger a suction handle a phillips
double zero screwdriver and some over
ninety percent isopropyl alcohol or
adhesive remover
we also recommend using a magnetic mat
to keep screws organized and safe the
galaxy s 10 plus has a ton of tiny
screws that are very easy to lose and
this mat will keep them all in place
only attempt to remove the display if
it's already broken you have to
disassemble most of the phone to get to
the display so only attempt this repair
if the display is fully damaged before
you begin your repair
make sure to discharge your battery
below 25% this will reduce the risk of a
dangerous thermal event if you puncture
your battery during the repair once
you're ready to get started
heat up an eye opener and lay it across
the right edge of the back cover lay a
suction cup on the back of the phone as
close as possible to where you applied
the heat and pull up on the suction cup
to create a gap between the back cover
and the case once you have a gap use the
pic to cut away the adhesive then leave
your pic in place to prevent the back
cover from resealing repeat the process
of heating lifting with the suction cup
and using your pick all around the phone
if the adhesive continues to give you a
hard time try using a heat gun or hair
dryer once you've cut the adhesive from
all around the phone twist the inserted
pics to help separate the back cover
from the frame once it's free you should
be able to lift it right off go ahead
and remove the 16 Phillips screws from
the NFC antenna charging coil and
speaker
[Music]
then use the tippier spreader to remove
them both from the phone
with your spread you're still in hand
disconnect the battery to cut off power
then go ahead and disconnect the display
cable as well the display is held down
by copious amounts of adhesive so we'll
need our eye opener to soften it place
your suction cup on the heated edge and
when you have your gap use your pick and
slowly move around the edge of the
display use a couple drops of isopropyl
alcohol to help soften the adhesive if
you ever feel that the adhesive is still
too hard try using a heat gun as well
use caution as you work around the left
side where the display cable is hiding
you don't want to cut it with all the
adhesive free you can remove the display
from the mid frame bring over your new
display and make sure you've applied the
new adhesive to the mid frame then
carefully slide the cable through the
slot in the frame and then lay the
display on to the mid frame once it's on
you can connect the display cable to the
motherboard make sure you don't forget
to connect the battery then go ahead and
insert the NFC antenna charging coil and
speaker and screw everything back in
with all that back in place and new
adhesive applied to your ear panel you
can carefully close up the phone
[Music]