over time the battery in the s10 plus
starts to lose this power and then you
might find yourself charging your phone
a bajillion times a day if you want to
get back to charging it just once a day
then keep watching we're about to show
you how to replace the battery on your
Samsung Galaxy S 10 plus for this repair
you'll need iFixit opening tools a
suction handle a set of I fix at opening
picks tweezers a phillips double zero
screwdriver an eye opener a spudger and
some over ninety percent isopropyl
alcohol or adhesive remover
we also recommend using a magnetic mat
to keep screws organized and safe the
Galaxy S ten plus has a ton of tiny
screws that are very easy to lose and
this mat will keep them all in place
before you begin your repair make sure
to discharge your battery below 25% this
will reduce the risk of a dangerous
thermal event if you puncture your
battery during the repair once you're
ready to get started
heat up an eye opener and lay it across
the right edge of the back cover lay a
suction cup on the back of the phone as
close as possible to where you applied
the heat and pull up on the suction cup
to create a gap between the back cover
and the case once you have a gap use the
pic to cut away the adhesive then leave
your pic in place to prevent the back
cover from resealing repeat the process
of heating lifting with the suction cup
and using your pick
all around the phone if the adhesive
continues to give you a hard time try
using a heat gun or hair dryer once
you've cut the adhesive from all around
the phone twist the inserted pics to
help separate the back cover from the
frame once it's free you should be able
to lift it right off
go ahead and remove the 16 Phillips
screws from the NFC antenna charging
coil and speaker then use the tip of
your spreader to remove them both from
the phone
with your spudger still in hand
disconnect the battery to cut off power
grab your isopropyl alcohol and begin to
drop some into the battery well let it
set and soften the adhesive then lift
the edge and tilt the phone so the
alcohol travels you can add some more
alcohol at this time if you wish wait
for about a minute for the adhesive to
finish softening and then grab a plastic
car door opening pick and pry up the
battery if the battery doesn't budge the
adhesive is not sufficiently weakened
reapply more alcohol or try using some
adhesive remover
with the old battery out grab your new
battery and apply new adhesive so that
your battery doesn't rattle around lay
your battery back inside the well and
reconnect it to the motherboard then go
ahead and insert the NFC antenna
charging coil and speaker and screw
everything back in with all that back in
place and new adhesive applied to your
ear panel you can carefully close up the
phone
Oh