
            D-Link DGE-550T Gigabit Ethernet Adapter Installation
                          for Windows XP

 Getting Started
 ---------------

    The Windows XP installation CD is needed to complete this
    installation.

    Installation Procedure under Windows XP 
    ---------------------------------------

    The following steps helps you install driver for your adapter:

     1. Make sure your computer is power-off.

     2. Plug the adapter into one PCI slot of your computer.

     3. Turn on the power. Your computer should be booting.

     4. Windows XP will find new hardware, and
        "Add new hardware wizard" will appear.

     5. Insert the driver diskette/CD into floppy/CDROM drive.
        Specify the path
        ( A:\, assume A: is floppy drive)
        ( D:\, Assume D: is CD drive)    

     6. Follow the instruction and the wizard will help you
        complete the installation.


 Driver keywords
 ---------------
     - Open 'Device Manager' in "My Computer" -> "Control Pannel" -> "System"
       Select "Hardware" and click "Device Manager".
       Double click "D-Link DGE-550T ...", Select "Advanced" item.

       Connection Type      Specify the connection type for the adapter.
                            Default: Auto-Negotiation

       Network Address      You can set the Ethernet address for your
                            adapter. It is not recommended to use this
                            keyword. As you know two or more adapter in
                            the same network with same Ethernet address
                            will cause a little problem.

                            When using this keyword you need to input
                            exactly 6 bytes of Ethernet address using
                            one of the following format:

                              xx-xx-xx-xx-xx-xx
                            OR
                              xxxxxxxxxxxx

                            Default: read address from adapter ROM.

       802.1Q/1P VLAN       You can enable it for VLAN group.
       tagging              Default: Disabled

       VLAN ID              This value will active after 802.1Q/1P VLAN
                            tagging enable.

       GVRP                 Support GVRP and will active after 802.1Q/1P
                            VLAN tagging enable.
                            Default: Disabled
                            
       Jumbo Frame Support  You can enable this for Jumbo frame support.
	   		    Default: Disabled
	   		    (The device or link partner should also support
	   		    Jumbo frame for this function to take effect.)
	   