D-Link Support Publishing       \PKTDRV\3SHARE.TXT              July 1996

        D-Link PCI Family Ethernet Adapter Packet Driver
                   Installation for 3Com 3+ Share

 Contents
 ÄÄÄÄÄÄÄÄ
     Introduction
     Requirements
     Minimum Skill Level
     Compatibility List
     Getting Started

 Introduction
 ÄÄÄÄÄÄÄÄÄÄÄÄ
    This installation assumes that the adapter is working properly.
    Getting Started will describe the installation instructions.

 Requirements
 ÄÄÄÄÄÄÄÄÄÄÄÄ
     A PCI compatible computer
     3COMs 3+ Share Open Network Operating System
     A PCI Family Series Adapter
     A knowledge of basic DOS commands and editing text files

 Minimum Skill Level
 ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ
     A knowledge of basic DOS commands
     A knowledge of editing text files
     A knowledge of DOS basic file structure (CONFIG.SYS and AUTOEXEC.BAT)
     A knowledge of the network driver configuration being used
     Please see Support Options if you are not comfortable with this
      skill level

 Compatibility List
 ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ
     Any PCI Family Ethernet Adapter
     For a Motherboard compatibility list please consult your local
      D-Link Branch Office

 Getting Started
 ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ

     Follow the installation procedure for 3Com EtherLink board.

     Copy the ETH.SYS file from the source directory of the driver disk
      into the boot disk. This program will replace the program of the
      same filename when the installation procedure in the first step is
      performed.

     Ensure that the CONFIG.SYS file in the boot disk or diskette
      contains the following two lines, in the given order:

        DEVICE = DLKPCI.SYS <-d> <-w> <packet_int_no>
        DEVICE = ETH.SYS

        <packet_int_no> is the software interrupt vector number used by the
                        packet driver program. This can be from 96 to 128.

        /d              Delay Initial - The driver program will not initialize
                        the network interface card until the packet driver
                        program is accessed by its upper layer program.

        /w              The -w parameter is for use only in the Windows
                        environment.

        See \PKTDRV\README.TXT for addition parameters

     You may now reboot and to start 3COM workstation.