Nov 1995
      DE-230 Series Ethernet Card Setup/Diagnostic program
     =======================================================

The DE230.EXE program (Setup/Diagnostic) lets you configure the DE-230
hardware settings, and test the state and cable connection of the card.

To run the program, insert the DE-230 driver program diskette in drive
'A' and do the following:

        > cd \UTILITY        --change directory to UTILITY
        > DE230             --run the DE230.EXE program

        or

        > cd \UTILITY        --change directory to UTILITY
        > DE230 /F          --run the DE230.EXE with parameter /F
                               if the data in your EEPROM has been corrupted
                               or you cannot configure your card through
                               normal procedure.

        or

        > cd \UTILITY        --change directory to UTILITY
        > DE230 /D          --run the DE230 with parameter /D
                               this parameter lets you Setup the DE-230 by
                               reading SETUP.DAT file. This way, you can
                               quickly configure your card without going
                               through the menus.

Menu Options
============

1.  DE230 lets you configure the hardware settings of DE-230.
    You have the option to view/change :

                   . Connector Type
                   . I/O Base Address
                   . Interrupt Number
                   . Remote Boot

2. DE230/F lets you configure your card if the data in your EEPROM
   has been corrupted or your cannot configure your card through
   normal procedure.

                   . Node ID
                   . Card Type
                   . I/O Base Address
                   . Interrupt Number
                   . Connector Type
                   . Remote Boot

3. DE230/D  lets you configure the card in non-interactive mode by using
   the /D switch.  The DE-230 program will automatically read the text file
   DE230.DAT located in the same directory.  The following is an example:

                   . Connector Type       UTP
                   . I/O Base Address     0x300
                   . Interrupt Number     5
                   . ROM Size             16k
                   . ROM Address          0xD0000

 Note:
   1. Setup will only change the setting that appears in SETUP.DAT, and other
      setting will not be changed.
   2. If any setting about boot ROM (ROM Size or ROM Address) appeared,
      boot ROM will be set to 'Enable'. Otherwise it will set to 'Disable'.
   3. If connector type is not configured, the driver will automatically
      detect the active media connector.

4. DIAGNOSTIC lets you diagnose the state and cable connections of DE-230.