EdgePower 54V-150W Changelog
===========================================================================

1.5.0 Changelog / Sept 24, 2019:
====
- added automatic check of new firmware availability in UI
- fixed bug when hosname in UNMS key wasn't sometimes resolved by DNS
- battery settings are now hidden when no DC PSU inserted
- DC Out is now recovered from overloaded state when it was caused by
  a temporary outage of one PSU
- added support for UNMS Mobile apps.
- various fixes/improvements for UNMS

Checksums:
File    | EP.v1.5.0.5aff31.190923.0924.bin
MD5     | ff6003e94b5487b1e9137e44c9055e43
SHA256  | b6b3b2b6c605c74c0d234f7ebe8353c4332ee68ceb6201c2a2f324f1c1033bd5


1.4.0 Changelog / Jun 19, 2019:
====
- Introduced new Dashboard
- Changed battery charger behavior - Battery charger is now enabled even if
  battery reach target voltage (in holding current state).
- Improved Low Voltage Disconnect function - DC Output was disconnected too
  earlier in some cases.
- Added Battery capacity and Installation date into Power tab
- Added support for Management VLAN setting
- Added support for Backup/Restore configuration
- Added Overloaded state - If actual power is higher than max power for 60s,
  disconnects outputs and after 10s tries to reconnect them again.
- Added support for reset total power consumption
- Fixed bug when Total power consumption was not reset during factory-reset
- Improved behavior when DHCP is used to get IP address and device is
  reconnected to other network (Device now tries to renew IP address)
- Improved UNMS support

1.3.1 Changelog / Nov 13, 2018:
====
- fixed power outage during reboot/upgrade
- fixed bug when PoE watchdog causes DC out to stay off

1.3.0 Changelog / Oct 3, 2018:
====
- added State to dashboard. Shows Online, PSU Offline, On battery,
  Battery low, Power off
- introduced new Power tab which will include all Power specific features
- replaced On/Off/Standby PSU properties with Priority options 
- added power-cycle for DC Output
- added ping watchdog: When EdgePower boots up, after a delay of 300 seconds,
  EdgePower starts checking selected IP address. If there is no response for
  3 times, DC output is power-cycled.
- added low voltage disconnect: When all batteries reach 11.8V,
  DC Output is turned off. This is indicated by Power off status.
- added timezone selection
- updated Discovery Responder
- enabled IPv6 Link local
- fixed bug when SSH authorized keys can not be imported
- minor fixes

1.2.0 Changelog / Jun 6, 2018:
====
- fixed bug when voltage was not correctly readed in some cases
- fixed WebUI dialog colors
- fixed WebUI dialog positions
- changed WebUI favicon
- minor fixes

1.2.0-beta.1 Changelog / Feb 1, 2018:
====
- added SNMP v1 support
- added UNMS support

1.1.0 Changelog / Aug 9, 2017
====
- enables DC/DC Module Support (Part #: EP-54V-150W-DC)
- backported discovery responder security fixes
- security updates to uclibc/openssl/lighttpd/php
- security fixes for WebUI CGI scripts
- default AC and DC module state handling, when configuration is not present
  while updating from v1.0.1 (Upgrading will not change the state of the PSU
  to off as it has in previous firmware upgrades.)