IBM eserver xSeries 345 Remote Supervisor Adapter II Update for Linux
System 8670

Version 1.05, Build ID: GEE833A, Revision 16 
CONTENTS
________

1.0  Overview
2.0  Change History
3.0  Installation and Setup Instructions
4.0  Unattended Mode
5.0  Web Sites and support phone Number
6.0  Trademarks and Notices
7.0  Disclaimer


1.0  Overview
________________________



        1.1     This will update the IBM Remote Supervisor Adapter II
                software only.  It will not affect any device drivers.  
        
        1.2     Limitations

                SSL is a commonly used security technology that uses encryption
                to provide secure TCP/IP communication.
                In order to comply with regulations regarding the export of 
                products that contain cryptography, the IBM Remote Supervisor 
                Adapter II is shipped without SSL support.  
                In order to install SSL, the installation key file must be obtained 
                and loaded into the Remote Supervisor Adapter II via the web interface.  
                Once the file is loaded, SSL is installed and can be enabled or 
                disabled as desired.
                
                If there is an error in loading the IBM Remote Supervisor Adapter II 
                software, retry loading the software by repeating the instructions 
                in section 3.0.

        1.3     Enhancements
                - none

        1.4.    Level of Recommendations and Prerequisites for the
                update:

                - none

        1.5     Dependencies:

                - none


2.0     Change History
________________________

IBM Remote Supervisor Adapter II Installation  Version 1.05
 - Corrected a problem with rebooting the ASM corrupting settings
 - Fixed an issue wherethe Remote control screen did not close
 - Fixed a problem where video was lost after cancelling remote disk
   image
 - Stopped a USB memory device from mounting as a CD ROM drive
 - Fixed a problem with the ASM not detecting an analog modem connected
   to the serial port
 - Removed the dialback command from the supported command list
 - Fixed a problem with remote graphics over a PPP connection
 - Fixed a problem that caused the ASM to reset when the Security
   link on the Web interface was clicked
 - Fixed a problem where the second login attempt was rejected
 - Intermittently the system did not redirect the local screen to console
 - Added new options under TCP via MIB file
 - Fixed a problem where the Windows blue screen capture would fail

IBM Remote Supervisor Adapter II Installation Version 1.04
 - Improved the recovery procedure for an ASM interconnect bus hang
 - Added support for Lightweight Directory Access Protocol
 - Added support for the Blue Identification LED
 - Added Remote Disk Multi Drive Support
 - Added Serial Console Redirection capability
 
IBM Remote Supervisor Adapter II Installation Version 1.03
 - Added support for the Belgian keyboard
 - Corrected a failure that occurred while flashing the Integrated Systems
   Management Processor
 - Corrected an ethernet connection problem
 - Fixed the save and restoration of the ISMP gateway setting  
 
IBM Remote Supervisor Adapter II Installation Version 1.02
 - Corrected the remote disk feature which would not work if
   it was run with a Japanese user name
 - Fixed a condition where alerts would not be generated after the system
   recovered from a CPU over temperature or system over voltage condition
 - Added SNMP command support
 - Added support for French, Italian, German, Spanish and UK keyboards
 
IBM Remote Supervisor Adapter II Installation Version 1.01
 - Provided the numeric pager alerts with different codes to distinguish
   faults from recoveries.
 - Corrected the firmware to recognize recoveries from ISMP detected
   faults on other systems connected via the ASM interconnect.
 
IBM Remote Supervisor Adapter II Update Version 1.00
 - First release

3.0  Installing and Setup Instructions
______________________________________

       This utility will update the IBM Remote Supervisor Adapter II
       software under the Linux Operating System .  It requires
       the installation of the correct Remote Supervisor Adapter II for
       Linux device driver.

       To use this utility, perform the following steps:

        a).     Copy filename.tgz (where filename is the name of the 
                file that you downloaded) to a temporary directory 
                on the hard disk.  Use GUNZIP (or similar utility) to
                access the compressed files.  Filename.tar will be unzipped 
                and placed in the directory where filename.tgz was located.  
                Use TAR (or similar utility) to extract the files in the archive.
        b).     In this directory, at the command prompt, type ./lflash -r  
                Text will scroll across the console screen while the update 
                process is occurring.  The update process could take up to 
                ten minutes to complete. 
        c).     When the utility is finished with the update, the text will 
                stop scrolling across the console screen and the adapter
                will be restarted.  The successful update ends with the
                text "Rebooting RSA...done".
        d).     Remove any diskette from the diskette drive and the 
                system is ready for use again.
        
        3.1   SSL Installation
        ______________________
        
         3.1.1   Begin a web interface session with the selected Remote Supervisor Adapter II.  
                 (See the Remote Supervisor Adapter II Installation and User's Guide
                 for more information on using the Remote Supervisor Adapter II web
                 interface.)

         3.1.2   Click on Security in the navigation panel.

         3.1.3   You are notified that SSL is not installed if the key file
                 has not been loaded previously.  Download the key file to a
                 location on your computer, and then specify the location of
                 the file as prompted on the Security page of the web interface.

4.0     Unattended Mode
________________________

        Once the files are extracted from filename.exe, the flash update
        can be completed by running 
                                      ./lflash -r
        at the command prompt.


5.0     WEB Sites and Support Phone Number
_________________________________________

        5.1     IBM Support Web Site:
                http://www.pc.ibm.com/support

        5.2     IBM eserver xSeries Web Site:
                http://www.ibm.com/eserver/xseries

        5.3     If you have any questions about this update, or
                problems applying the update, go to the following
                Help Center World Telephone Numbers and URL:
                http://www.pc.ibm.com/qtechinfo/YAST-3P2QYL.html.

6.0.    TradeMarks and Notices
______________________________

        6.1     The following terms are trademarks of the IBM 
                Corporation in the United States, or other countries
                or both:
                            * IBM
                            * Netfinity
                            * Netfinity Manager
                            * Advanced System Management

                Other company, product, and service names may be
                trademarks or service marks of others.

7.0.    Disclaimer
__________________

        7.1     THIS DOCUMENT IS PROVIDED "AS IS" WITHOUT WARRANTY OF
                ANY KIND.  IBM DISCLAIMS ALL WARRANTIES, WHETHER EXPRESS
                OR IMPLIED, INCLUDING WITHOUT LIMITATION, THE IMPLIED
                WARRANTIES OF FITNESS FOR A PARTICULAR PURPOSE AND
                MERCHANTABILITY WITH RESPECT TO THE INFORMATION IN
                THIS DOCUMENT.  BY FURNISHING THIS DOCUMENT, IBM
                GRANTS NO LICENSES TO ANY PATENTS OR COPYRIGHTS.

        7.2     Note to Government users:

                Note to U.S. Government users-- Documentation related
                to restricted rights-- Use, duplication and disclosure
                is subject to restrictions set forth in GSA ADP Schedule
                Contract with IBM Corporation.



