Copyright 2006 Altima Technologies, Inc. All rights reserved.
Title Height in Inches
Subtitle Height in Inches
Line Height in Inches
<Subheading>
LEGEND
Set to one wave in one inch
Set to two waves in one inch
Set to three waves in one inch
Set to four waves in one inch
Set to five waves in one inch
Set to six waves in one inch
Wave width
Wave Frequency
Frequency
Wave Width
Connection Standards
T1 PSTN Trunk (ISDN)
T1 TIE Trunk (ISDN)
CO PSTN (Analog Loop/Wink/CAMA)
10 Mb/s Ethernet (Unpowered)
100 Mb/s Fast Ethernet (Unpowered)
1000 Mb/s Gigabit Ethernet (Unpowered)
10 Mb/s Ethernet (802.3af Powered)
100 Mb/s Fast Ethernet (802.3af Powered)
1000 Mb/s Gigabit Ethernet (802.3af Powered)
802.11
DSL
Cable Modem
T1 Data (Pt-to-Pt Frame Relay, MPLS)
Fiber Optic
Analog Line
Digital Line
100 Mb/s Fast Ethernet (802.3af powered)
1000 Mb/s Gigabit Ethernet (802.3af powered)
T1 Data (Pt-to-Pt, Frame Relay, MPLS)
How To Use The Legends Stencil
Drag the appropriate legend shape into your drawing. Use the Large Legend for C and D size drawings. Use the Small Legend for Letter, Legal and Tabloid size drawings.
Place the legend on your drawing.
Ungroup the Legend shape.
Visio will alert you to the fact that this will unlink the shape from the master.
Click OK.
Delete the line types you will not be using.
Move the remaining lines to the BOTTOM of the legend.
Ensure each line snaps into place on the legend frame. The endpoints will turn red when the line is snapped into place.
Push up on the bottom of the legend frame until the legend is the appropriate size.
How to use SineWave and SquareWave
Use the Line tool to draw a line where needed.
With the line selected, select Format > Line
Click the drop-down menu for Pattern and choose Sine
Click the drop-down menu for Weight and select Custom...
Set the Line weight: to 0.1 pt.
Click OK
Your line should look something like this.
The same procedure applies to SquareWave except from the Pattern menu choose Square