Well we have different grounds to the same destination and the roads all have the same road attributes
that is distance priority or maybe metric then differing it will load balanced the traffic.
Now this is called equal cost multi path ICMP but we can change the way or the parameters that 48 loan
balances the traffic.
Let's see how we do it.
Let's get over to our command line config system settings
set V4 ECM P mode.
Now if you scroll you will see four different methods.
The first one source IP based all traffic that comes from the same source will be destined to the same
route weighted IP based wav IP based.
That is all traffic will be routed or will be distributed between different interfaces.
And that is according to a weak number that we will configure on the different interface.
We will look at it in a minute usage IP based.
All traffic will be distributed towards a specific interface.
And that is until a volume threshold is approached.
We will also see how we configure and volume threshold to an interface.
When it approaches the threshold approaches then the traffic will move to another route.
And the last one is the source destination IP.
And that is the same as source site.
But it also includes the destination.
That is all traffic that comes from the same source and destined to the same destination will follow
the same route.
That's config await to our
tor interface.
Let's use when one set way.
And now higher weights are likely to be chosen.
That is the traffic will be distributed between the different interfaces all the different rules but
interfaces or routes that has higher weights will probably get more traffic.
Now we can set up the weight between 0 and 255 so let's set it up to two hundred and fifty five.
And that's it.
So if we choose the wafer PE method one one would probably get more traffic than other arouse other
same routes that has lower weights when we use these pill over method.
That is when threshold volume is approached on a specific round or an interface the traffic will flow
to the second route.
Now how do we set up a volume threshold.
We use the same config sys interface.
Edit the interface or the rule that we want to configure the threshold and then we use the set spill
over threshold and that is a value between 0 and 16 million so that's just choose
no right.