All right so let's start our journey.
You don't have to have a physical device you can use a that support site and download a virtual image
of 40 gauge device into your virtual environment.
Once you get into the support side create an account download a virtual image you can choose your platform
of choice.
I'm currently using a VM where and there are different versions that you can use.
I'm using six point O point four and download it in your own time now.
The next thing to do is to head over into your virtual environment import your image and continue the
setup.
Once it is done you will be asked to log in into your 48.
Use the the admin the user now with no password.
And there you are.
You're at the 40 gate command line where we will see using show system interface the different interfaces
that are available.
I remind you we will now setup a management interface.
We will now set up an interface that we will use that as an admin to get into our 40 gate and configure
the different settings configure policies set up new interfaces to do so let's choose port 7 as our
management interface.
We will use the following command config sis interface edit port 7 set IP.
Now this IP will be used as our management interface set IP.
We will choose the 10 that zero the three that 16 as All right pick up the subnet mask will be 255 255
255 0.
The next thing is to set up the management protocols that will be used to get into that interface where
we can use H2 G.P.S..
We can use HDP.
We can also use SSL.
But in our case we will only use H2 DP
and that's it.
Now the next thing to do is to get on to our browser use the IP address that we have used as our management
interface.
10 0 or the treat.
That's 16.
And we will be prompt to enter a user credentials.
We will stay with the default credentials which are ad would no pass for it.