In this hands-on lab for SwitchPort Analyzer, here's what I love you to do.
I love you to play with Switch 1, Switch 2, and set up R-Span.
And for the requirements, I'd like you to set up Switch 2 with the source port
of Gig 01.
If you want to, you can specify VLAN 1 instead because that client is on VLAN 1
,
but that would collect all the VLAN 1 traffic and not just the traffic on that
specific port.
But either way is fine. If you want to do it both ways, that's also fine.
And then for the R-Span VLAN, I like to use 999 as the R-Span VLAN.
And then for the destination of that R-Span traffic, I'd like to have Switch 1 WEBVTT X-TIMESTAMP-MAP=LOCAL:00:00:00.000,MPEGTS:900000
And then for the destination of that R-Span traffic, I'd like to have Switch 1
pull that data from VLAN 999
and then send it out Gig 3/3.
I'll also have as part of the skill some useful and helpful commands in config
uring that.
You can also review the video where we did R-Span for any tips for help as well
.
So that my friend is the hands-on lab. Have some fun with it.
And when you are done and ready for a walkthrough of these tasks, join me in
the following video.
Meanwhile, have fun with the lab.