In this hands-on lab, here's what I'd love you to do. I'd love you to take the
topology that we have
and that we've been working with and enable OSPFV3 specifically for the address
family IPv6
as shown in that topology. Then once you implemented that and verified it, then
like you do the
following. I'd like you to configure area two on the right hand side of our top
ology,
configure it as a totally stubby area, meaning no LSA type 5s, no LSA type 4s,
and no LSA type 3s,
except for the default route that the area border router will advertise into WEBVTT X-TIMESTAMP-MAP=LOCAL:00:00:00.000,MPEGTS:900000
except for the default route that the area border router will advertise into
area two.
And then once you've configured and verified that, next I'd like you to go
ahead and summarize
the routes in area one that begin with these 48 bits, 2001, DB8673, and
summarize those
before advertising any LSA type 3s up into area zero, which is not only similar
to what we did in
the previous video, but it is exactly what we did in the previous video. So if
you need to refer
back to any of the previous videos, feel free to do that. So have some fun with
the hands on Lab
and while you're doing that, I'm going to go ahead and reset my Lab environment WEBVTT X-TIMESTAMP-MAP=LOCAL:00:00:00.000,MPEGTS:900000
and while you're doing that, I'm going to go ahead and reset my Lab environment
to the starting point
and then when you're done with the Lab and want to do a walkthrough of the
solution together,
join me in the next video. Until then, happy Labbing and I'll see you soon.